MelodySusieTungsten Carbide Cuticle Cleaner Safety Nail Drill Bit Fine
Carbide drill bit that cleans the cuticle area and exposes the nail plate, so your gel polish lifts less. Turns both ways and fits at 3/32 inch on most drills.
Description
The MelodySusie Tungsten Carbide Cuticle Cleaner Safety Nail Drill Bit Fine is a carbide drill bit for the cuticle area. That area is where gel polish lifts first, and usually because a thin layer of skin is still sitting on the nail plate.
With this bit you clean that edge and expose the nail plate, so your product bonds better and stays on longer. The YG6X carbide is heat resistant and hard wearing, and the bit turns both ways, so left and right handed both work. The 3/32 inch shank fits most electric nail drills.
This drill bit:
- cleans the cuticle area and exposes the nail plate
- prevents lifting, because product bonds badly to skin residue
- is made of YG6X carbide, heat resistant and hard wearing
- turns both ways, so left and right handed
- fits at 3/32 inch on most electric nail drills
- is cruelty free
How to use
- Click the bit into the handpiece and check that it is seated properly.
- Push your cuticles back first, so you can see where the skin ends.
- Start on a low setting and work along the edge with the side of the bit.
- Keep the bit moving and work with light pressure, never on the skin itself.
- Clean the bit after every use and store it dry.
- Never reuse a bit that has been dropped: it can break while it turns.
Questions (3)
Which grit do I need?
Coarse takes material off fast and is what you use to break down acrylic or gel. Medium sits in between, for shaping and backfill. Fine takes off little per pass and is for smoothing and finishing. If you work on your own nail, stay with fine. All grits are at the nail accessories.
Does this bit fit my nail drill?
The shank is 3/32 inch, or 2.35 mm, and that is the size almost every electric nail drill uses. If you are not sure, check the manual of your drill or measure the opening of the handpiece. All of our nail drills work with it.
How do I clean a drill bit?
Brush the dust out, clean the bit with water and soap or a small brush, and disinfect it afterwards. Let it dry completely before you store it, otherwise moisture builds up. A bit that has been dropped is one you stop using: it can break while it spins.
